The following options are available: Control Panel Opens the control panel for the audio hardware. Input Latency Shows the input latency of the audio driver. Output Latency Shows the output latency of the audio driver. Clock Source Allows you to select a clock source. Externally Clocked Activate this option, if you use an external clock source.
Direct Monitoring Activate this option to monitor via your audio hardware and to control it from Cubase. Ports Reset Allows you to reset all port names and visibilities. I/O The port input/output status. Port System Name The system name of the port. Show As Allows you to rename the port. This name is used in the Input Routing and Output Routing pop-up menus. Visible Allows you to activate/deactivate audio ports.
Asio direct sound full duplex driver download, GetGo Download Manager 4.7.3.1085, Bluetooth Driver Installer 1.0.0.84, Mac the Scope 4.0b1. Dec 18, 2010 REALLY Annoying Cubase/Asio/Audio Interface Problem. Also, when I switch back to the ASIO DirectX Full Duplex driver I get this error. Read the manual or getting started quick manual for setting up your audio device. Set up the edirol driver in your VSTaudio settings in devices.
State The state of the audio port.
Note: this article only applies to Windows (specifically Windows 7 and above) The general rule of thumb is: if possible try to select in this order: ASIO, WASAPI, DirectSound (default mode). DirectSound - this is the standard audio mode on Windows (along with MME but we don't use that in FutureDecks). It always works but it almost always works only in stereo mode and outputs only. What this means is that even if you have a soundcard with multiple inputs and outputs, you will most likely get working only 1 stereo output (without the other outputs and inputs). The latency is extremely big (usually between 50ms and 80ms) so you can't properly scratch or do any true real-time work. Also, you can't use timecodes (since you don't have any inputs and the latency is very bad). Getting separate heaphones/speakers signals is tricky since you almost always only get a single stereo output (maybe you can use split mode - use left channel for speakers and right channel for headphones).
Cubase Asio Driver
You should use this only if your audio device doesn't support the other modes. WASAPI - this is a lot better than DirectSound as it provides less latency (usually between 10ms and 30ms) so it's more suitable to real-time use. It also provides access to both inputs and outputs and multiple channels (if it's properly configured in Windows). There are some problems (like out of sync between outputs and inputs, pops, clicks, stutters, etc) in full-duplex mode (using both outputs and inputs) on some audio devices but in general it works ok. You should use this if your soundcard doesn't have an ASIO device. ASIO - use this whenever you can.
Asio Driver For Cubase 9.5
This is by far the best audio mode possible in Windows. It provides extremely low latencies (usually between 1ms-10ms) so it's perfect for timecodes, scratching and pretty much anything that you want to be real-time.
Unfortunately not all audio devices (soundcards) have a driver for this. You need to check the CD that came with the device or look at the manufacturer's website for a specific driver for your device. Alternatively, you can use ASIO4ALL (a software which simulates ASIO for an audio device without one) but you might get mixed results - it might work perfectly or it may not. You should always choose this interface/mode when possible. So, once more: use ASIO if it's available for your audio device. If not, use WASAPI and only as a last resort use DirectSound.